Msd 6425 Digital 6AL Ignition Control Uživatelský manuál stáhnout pdf

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

FRM30943 Created 01/12 Printed in U.S.A.

REV Limiter Veriﬁcation

MSD Digital 6AL Ignition Control

PN 6425

The MSD Digital 6AL has an optional built in Rev Limiter Veriﬁcation feature. When activated, it will display the

unit’s rev limit setting at key-on. This feature is not activated from the factory. To enable this feature, follow the

procedure below.

Note: It is important to note that this feature should not be used with EFI systems. When activated, an rpm

signal is sent to the tachometer. With an aftermarket EFI system, this could activate the injectors causing

a ﬂooding situation.

ENABLE REV LIMIT VERIFICATION

1. With the ignition switch in the off position, ground the Gray tach output wire.

2. With the Gray wire connected to ground, turn the ignition on without starting the engine.

3. Hold the Gray tach output wire to ground for seven seconds. (AT LEAST ﬁve seconds.)

4. Release the wire from ground before ten seconds have passed.

5. To conﬁrm the process has worked, cycle turn the key On. The tachometer should sweep to the rpm limit

set on the ignition.

To deactivate the veriﬁcation feature, repeat the process.

Žádné komentáře

Msd 6425 Digital 6AL Ignition Control Uživatelský manuál